THE JQRacing Hex Pin and Grubscrew

Price
$7.49
Availability
Temporarily out of stock
Part No. USA-JQB0072

THE JQRacing Hex Pin & Grubscrew Set includes four hex pins, and four grub screws.

I decided to change the way the wheel hex is attached to the driveshaft. All other 1:8th Buggies have a lot of slop in the axle to bearing attachement. By using a crush spacer between the bearings, and an elongated hole in the driveshaft axle, it is possible to eliminate all slop in this fixture. You may need to use a shim or two along with the spacer. The driveshaft should spin freely after the hex pin grubscrew is tightened. There is no need to overtighten the hex pin. Use locktite, tighten so it is snug, that’s it!

Your search did not return any products. You can try again or browse our product below.

Your search did not return any products. You can try again or browse our product below.